Factors To Consider When Choosing A Wood Connector Iron Face Plate Size

One of the most common questions that both builders and homeowners have when it comes to incorporating decorative or structural iron beam straps with timbers has something to do with the ways on how to choose the right wood connector iron faceplate size for exposed beams. For those of you out there who are thinking of having a new construction project, please be guided about how you will need either an architect or an engineer here since they are the ones who can help specify all the requirements you need for your application, which may include the size, the width and the minimum thickness of iron faceplates. That is not it at all as there are more that you need to know about the importance of architects and engineers like how they are necessary for determining both the diameter and the length of the fasteners (either the bolts of the lags) that are used in attaching the wood construction tie, which plays an important role in identifying the structural value of the post beam connection. The difference between bolts and lags as fasteners is that bolts can be rated as a structural grade eight as it can be bolted in through the beam using a nut on the other end while the lag only has a pull out value, which means that it can only be rated as a grade five in structural integrity.

When it comes to matter concerning the selection of the right wood connector iron faceplate size that you can use for your existing beam structure as you want to add additional support to it, one of the most important factors that we want you to consider is to always remember that you are simulating a structural support beam. With regards to this matter at hand, it would be best for you to select a wood connector iron faceplate size that is large enough so that your structural beam support will come out as something that really has a great value to it. If you want to know how you can get the right size for your wood connector iron faceplate, we suggest that you cut a template out of a paper and then tack it, or tape it or staple it to your beam. You can also start by cutting a template having the sizes of two inches wide and eight inches long or tall.

Another way on how you can get the right size for your wood connector iron faceplate is by means of using a black poster board or you can choose to paint your template black so that you can visualize it much better, though you must not worry about the actual design since your focus should be the basic size.

Doing Cladding The Right Way

Doing Cladding The Right Way